Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 69)

HOME
screen
or
MENU 2
screen
MENU 1 screen
Press
Press
Press
Pu h Press
If the power switch is turned on
while the idle-up switch is on, an
audible alarm will be heard. Im-
mediately set the Idle-Up switch to
OFF.
69
Fu
n
c
tio
n
Idle-Up
Idle up
On
Idle up
O f f
Idle up ON/OFF is displayed
by pop-up window in the home
screen.
Warning display
This is a function select switch function. The idle-up function switch must be set. (p.99)
It is used to improve engine starting performance by raising the idling speed when the en-
gine of a gasoline car (boat) is started.
This function is also effective when you want to prevent braking when the power was
turned off during running due to the effect of gear ratio setting and the motor used with
a motor car. However, when using the MC960CR, MC950CR, MC851C, MC602C, MC-
402CR, etc., check the ESC neutral position and set the idling function switch to ON after
the set enters the operation mode, the same as the neutral brake function (p.66).
The throttle neutral position is offset to the forward side or brake side. There is no link-
age locking, etc. because there is no change near the maximum operation angle even
when the neutral position is offset by this function.
Operation
Idle-Up on/off state.
(Preparation)
- Use the function select switch function to select the switch. (p.99)
1
(Idle-Up rate)
Use the (+) and (-) buttons to set the Idle-Up rate.
2
When ending setting, return to the menu screen by pressing
the (END) button.
Idle-Up function adjustment
Idle-Up "IDLUP" (Throttle system)
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Idle-Up Rate
-50 ~ 0 ~ +50
Idle-Up rate
-50 ~ 0 ~ +50
"-": Brake side
"+": Forward side
Initial value: 0%
The display appears on the home screen.
Operation Display