Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 125)

When using in races in which the lead angle setting function is inhibited by the ESC, set "Lead
angle use" to "INH". The "Lead angle use" setting has priority over "Turbo mode". If "Lead angle
use" is set to "INH", the lead angle setting function can be turned off even if "Turbo mode" is set to
"Turbo1" or "Turbo2".
The MC940,960CR shows that the lead angle setting function is OFF ("0" timing) by blinking a LED.
The "Lead angle" and "Point A, B, C, D, E Lead angle" relationship is shown on the graphs below. Graph
[1] shows the relationship when the same value is set at "Points A, B, C, D, E Lead angle" of [1] and [2]
and the "Lead angle" was set to "0" and graph [2] shows the relationship when a value other than "0" was
set at "Lead angle". As shown in the graphs, [2] is added to the "Points A, B, C, D, E Lead angle" set lead
angle and [1] is added to the "Lead angle" set lead angle. For example, if "3" is set at Point A and "Lead
angle" of [2] is set to "2", the actual Point A becomes 3+2=5 (deg). Since "Lead angle" of [A] is "0", the
actual Point A also becomes 3+0=3 (deg).
A B C D E
A
B
C
D
E
1 (Lead angle ="0") Lead Angle(deg)
rpm
Turn on "Lead angle use"
A B C D E
A
基準進角
B
C
D
E
2 (Lead angle >"0") Lead Angle(deg)
rpm
Lead
angle
125
Fu
n
c
tio
n
MC Link Function (ESC Link)
Lead angle use
MC940,960CR :ACT/INH
Same as Link software Lead Angle Use.
This function is effective when Turbo Mode is Turbo1 or Turbo2 and sets
whether or not lead angle is used. This setting has priority over the Turbo
Mode setting. When using in races in which the lead angle function is inhib-
ited by the ESC set this function to INH.
INH : Lead angle function not used.
ACT : Lead angle used
Lead angle
MC940,960CR :0deg~59deg
Same as Link software Lead Angle.
When "Lead Angle Use" is turned on the motor lead angle can be set at the
MC960CR. The lead angle can be set up to 59 degrees in 1 degree incre-
ments.
Point A,B,C,D,E Lead angle
MC940,960CR :0deg~59deg
Same as Link software Boost Angle.
Point A,B,C,D,E Rotation
MC940,960CR :0rpm~99990rpm
Same as Link software Boost Angle rpm.
When "Lead Angle Use" is turned on the lead angle versus motor speed of the 5 points A to E can be set. The lead
angle can be set up to 59 degrees in 1 degree increments.