Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 66)

HOME
screen
or
MENU 2 screen
MENU 1
screen
Neutral Brake
0~100 Initial value: 0
Press
Press
Press
Press Trigger ratio
Forward50:Brake50
Forward70:Brake30
Forward100:Brake0
Trigger switch point
-100~+100
Initial value: +100
66
Fu
n
c
tio
n
Forward 50:Brake 50 Forward 70:Brake 30 Forward 100:Brake 0
Forward side Forward side Forward side Brake side Brake side Brake side
5 : 5 7 : 3 10 : 0
When the trigger ratio was set to 100:0, brake operation stops and the neutral brake can-
not be used.
When trigger ratio was set to 100:0
-The trigger switch function operates the trigger as a switch.
The trigger point can be selected and mixing, engine cut, and other functions can be turned
on and off.
The display appears on the home screen.
Operation display
Trigger
-The neutral brake function is a function switch function (p.99), and setting the neutral
brake function ON/OFF switch is necessary.
Neutral brake, which applies the brakes at the throttle trigger neutral position, can be set.
However, for Futaba speed controller (ESC) MC960CR, MC950CR, MC851C, MC602C,
0&&5HWFFRQVLGHULQJVDIHW\ZKHQWKHQHXWUDOSRVLWLRQLVQRWFRQ¿UPHGWKHVHWZLOO
not enter the operation mode to prevent the motor from rotating instantly when the power
is turned on. When using the MC960CR, MC950CR, MC851C, MC602C, MC402CR, etc.,
check that the ESC is in the neutral position and set the neutral brake function switch to ON
after the set enters the operation mode.
Trigger (Throttle system)
-This function allows selection of the forward side and brake (reverse) side operation ratio
from 70:30, 50:50 or 100:0 by changing the neutral position of the throttle servo.