Mechanical atl adjustment, Wheel & trigger tension adjustment – Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS User Manual

Page 18

Bef

ore U

Mechanical ATL
adjusting screw

Adjustment

Using a 1.5mm hex wrench, adjust the trigger

brake (reverse) stroke. (The screw moves the

throttle trigger stopper.)

• When the screw is turned clockwise, the stroke becomes

narrower. Adjust the stroke while watching the screw.

Note:

Mechanical ATL Adjustment

Make this adjustment when you want to decrease the stroke of the brake (back) side of the
throttle trigger for operation feel.

Wheel & Trigger Tension Adjustment

Make this adjustment when you want to change the wheel or trigger spring’s tension.

Adjustment

Using a 1.5mm hex wrench, adjust the wheel

spring tension by turning the screw inside the

adjusting hole in the arrow direction.

• The spring is set to the weakest tension at the factory.
• When the adjusting screw is turned clockwise, the spring

tension increases.

Note:

Wheel tension

adjusting screw

Once you have changed the mechanical stroke on the brake side, be sure to adjust the
scale of the throttle channel accordingly by using the "Adjuster Function" (p.128).

Due to this change, you also need to adjust in most cases the travel of the throttle servo
by using "Data Setting."

The adjustment range is up to 7 to 8 turns from the fully tightened (strongest) position. If
turned farther than this, the adjusting screw may fall out.

Trigger tension

adjusting screw