Telemetry :temperature, Fu n c tio n – Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS User Manual
Page 135

Telemetry screen
Press
Press
The voice guide loading inter-
val is set by sensor menu.
135
Fu
n
c
tio
n
Telemetry
Current temperature
Limit temperature setting
(Temperature that sounds an
alarm)
The Speech function (ON/OFF)
Alarm and vibrator ON/OFF and type set-
ting (The arrow indicates that an alarm
is generated when the speed drops below
the set value and the arrow indicates that
an alarm is generated when the speed ex-
ceeds the set value.)
A temperature sensor must be installed in the model car.
Install and connect the sensor in accordance with the
sensor instruction manual.
The minimum and maximum the
when powering ON are shown.
1
(Limit adjustment)
Select the setting item "
Limit" or "
Limit
"
by (JOG) button up, down, left or right operation.
Use the (+) or (-) button to adjust the limit voltage.
2
(Alarm and vibrator function setup)
Select the setting item "
Alarm" or "
Alarm" by (JOG) button up, down, left or right opera-
tion. Set the function to the active state by pressing the (+) or (-) button.
"Inhibit" :No audible alarm / "Buzzer" :Audible alarm/ "Voice" :Voice alarm
Select the setting item "
Vibrator" or "
Vibrator" by (JOG) button up, down, left or right op-
eration. Press the (+) or (-) button and select the type.
"Inhibit" :No active vibration/ "Type1" :Continuous vibration/ "Type2" :Intermittent vibration for a long time/
"Tyoe3" :Intermittent vibration for a short time
3
(Speech function setup)
Select the setting item "Voice" by (JOG) button up,
down, left or right operation. Set the function to the ac-
tive state by pressing the (+) or (-) button.
"OFF"
:No voice guide
"ON"
:Information loaded by voice
4
When ending setting, return to the Telemetry menu screen by pressing the (END) button.
Alarm and Vibrator function setup
Telemetry :Temperature
This screen displays and sets the temperature information from an SBS-01T (telemetry
temperature sensor) sold separately. The temperature of the engine, motor, amp, etc. of the
chassis while running can be viewed at the transmitter.
When the temperature becomes higher (lower) than the set value, it can be announced by an
alarm and vibration.