Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 123)

MC940,960CR MC401,402CR MC950CR
MC940,960CR
MC940,960CR/MC950CR
123
Fu
n
c
tio
n
MC Link Function (ESC Link)
Reverse cancel
MC401,402CR/MC950CR/MC940,960CR :ACT/INH
Same as Link software Reverse Cancel.
When set to "ACT", reverse operation is not performed.
Robot mode
MC401,402CR/MC950CR/MC940,960CR :ACT/INH
Same as Link software Robot Model.
When set to "ACT", breke operation is not performed, there is only forward and reverse operation.
Brake slope
MC940,960CR/ :0~300
Same as Link software Brake Slope.
This function adjusts the braking effect when the throttle was returned (throttle
off). It cancels operation like that called engine brake of actual vehicles.
Brake timer
MC940,960CR/MC950CR :0sec~300sec
Same as Link software Brake Timer.
When the reverse function is used, ordinarily if the trigger is not moved to the
brake (reverse) side and then returned from the brake operation position to the
neutral position, reverse operation will not be performed. However, when used
by intentionally moving the neutral point to the forward side, if brake operation
is repeated, reverse operation may be performed even if the trigger is not re-
turned to the neutral position. The time required to switch to reverse operation
can be set to prevent this from occurring.
Lead angle
MC950CR/ :0~1500
Same as Link software Lead Angle.
The lead angle of the motor can be set at the MC950CR side. However, we
recommend that it normally be set to "0". Since this setting is premised on
setting by referring to the speed log by the Link software.