Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 152)

System menu
Setup item
Calibration(wheel)
Calibration(trigger)
Setup item selection
- Select by (JOG) button opera-
tion.
-Setup buttons
- Use the (JOG) buttons to
make setup.
152
Fu
n
c
tio
n
1
(Steering neutral adjustment)
After pulling the wheel was lightly to the left or right, press
the (JOG) button in the state in which the wheel is not
touched. If neutral correction is OK, the end point correction
screen appears. If not within the correction range, the end
point correction screen will not appear.
Calibration
Steering and throttle correction can be applied. Use this function when a mechanical offset
has occurred for some reason.
(Preparation)
Select "Wheel" (steering side) by (JOG) button left or right
operation and press the (JOG) button. The neutral correction
screen appears.
Steering adjustment
S
-
-
-
2
(Steering wheel travel adjustment)
In the end point correction screen (figure at the right) state,
lightly turn the wheel fully to the left and right and press the
(JOG) button. If end point correction is OK, the display re-
turns to the adjuster screen. If the end point is not within the
correction range, the display does not return to the adjuster
screen. In this case, return to the system menu screen by
pressing the (END) button. If operation cannot be ended nor-
mally even when correction is repeated, please contact the
Futaba Service Center.
3
When ending setting, return to the system menu screen by pressing the (END) button.
Calibration
However, if correction was applied, it may be necessary to recheck the set values of all
the setup functions.
Press
This setting is displayed from the screen of the system menu. (p.144)