Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 57)

or
MENU 1 screen
HOME
screen
MENU 2
screen
EXP curve screen
Curve type which operates the
throttle from the neutral point
to the high point on a curved
curve.
VTR curve screen
Curve type which sets the switching
point between the throttle neutral
point and high point and operates
the throttle on a linear curve.
CRV curve screen
Curve type which sets 9 points
between the throttle neutral point
and high point and operates the
throttle.
Press
Press
Press
Press
The throttle EXP curve and VTR curve adjustment (Foward side RATE) and(Brake side
RATE) can be controlled with digital trim DT1~DT6 or digital dial DL1 etc. with the
function select dial function. (p.101)
Dial / Trim Setting
When Trigger Ratio (p.66) was set to 100:0, brake operation is stopped and the throttle
(brake side) cannot be adjusted.
Caution
Curve selection
First, select the type of forward side curve at the "Type" item. The
setup item (screen) varies with the type of curve. The figure at the
above is the EXP curve setup screen.
Pre Press
57
Fu
n
c
tio
n
Throttle curve
Throttle curve (Throttle system)
This function makes the throttle high side and brake side direction servo operation
quicker or milder. It has no effect on the servo maximum operation amount.
For the high side, selection from among three kinds of curves (EXP/VTR/Curve) is also
possible.
When the course conditions are good and the surface has good grip, set each curve to the
+ side (quick side). When the road surface is slippery and the drive wheels do not grip it,
set each curve to the - minus (mild) side.
Advice