Caution, S.bus servo, Fu n c tio n – Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS User Manual
Page 126

HOME
screen
or
MENU 2 screen
MENU 1
screen
Cover
Connecting S.BUS/S.BUS2
servo connector to the trans-
mitter Communication port.
126
Fu
n
c
tio
n
S.Bus servo
-When the T4PX battery voltage drops, since the display switches to low battery display,
XVHWKLVIXQFWLRQLQWKHVWDWHLQZKLFKWKHUHPDLQLQJEDWWHU\FKDUJHLVVXI¿FLHQW
-Power is supplied to the servo from the transmitter, but the corresponding voltage is for
high voltage servo (HV) use. Since an overvoltage will be applied to servos other than
this, connect the corresponding battery to the servo. When the battery is connected, the
supply of power from the transmitter automatically stops.
Caution
When connecting an S-BUS servo that does not support high voltage, connect a battery
matched to the servo specifications.
High voltage servo support voltage is supplied from the transmitter. If a servo that does not support high voltage is
connected, unreasonable force will be applied to the servo and will cause trouble.
Communication port
S.Bus Servo
This is a special function which allows Futaba S.BUS/S.BUS2 servo parameter changes to
be set by the T4X transmitter.
However, some data changes require a PC and S-Link software.
This function is used by connecting Futaba S.BUS/S.BUS2 servo directly to the transmitter.
8VHWKHYDULRXVRSWLRQDOVHUYRH[WHQVLRQFRUGVDFFRUGLQJWRWKHGLVWDQFHEHWZHHQWKHWUDQVPLWWHU
and servo.
Press
Press
Press
Press