Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 72)

Engine cut
On
Engine cut
O f f
If the power switch is turned on while the preset
(engine cut) switch is on, an audible alarm will be
heard. Immediately set the preset switch to OFF.
72
Fu
n
c
tio
n
When the trigger ratio (p.66) was set to 100:0, the brake function does not operate. The
preset position set here becomes the linkage standard. The linkage is set so that the car-
buretor is fully closed and the engine is stopped within the preset adjustment range. The
full throttle position is set by
"Forward" of the end point function. The idling position is
adjusted by throttle trim.
When trigger ratio was set to 100:0
Engine Cut
When engine cut is active,
ON is displayed.
(Preparation)
- This is a function select switch function. The engine cut func-
tion switch must be set. (p.99)
- The engine cut is turned on with the set switch.
1
(Preset position setup)
Use the (+) and (-) buttons to set the preset position of the
throttlle servo.
"B100" ~ "B1" :Brake side
"0" :Neutral
"F1" ~ "F100" :Forward side
Engine Cut function adjustment
2
When ending setting, return to the menu screen by pressing the (END) button.
Warning display
The throttle servo operating position (preset position) set by this setting is unrelated to
the setting of other functions. Maximum to minimum servo travel can be set. However,
the reverse function setting is enabled.
Caution
Always operate carefully before using this function.
While push switch PS1~PS5, or trigger switch TS with preset function set is in the ON state, the servo (motor controller) is
locked in the preset position and does not operate even if the throttle trigger is operated. If the servo was operated at the
wrong setting, you may lose control of the car (boat).
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Preset rate
0 ~ 100
Initial value: 0%
Engine cut up ON/OFF is dis-
played by pop-up window in
the home screen.