Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 132)

Telemetry screen
The voice guide loading inter-
val is set by sensor menu.
132
Fu
n
c
tio
n
Telemetry
Telemetry :Receiver Battery
This function displays and sets the receiver power supply battery. The sensor sold separately
does not have to be installed. The transmitter initial state voltage is also displayed. For a
description of alarm setting when the voltage drops, see the description of the procedure on
this page.
Sets the limiter voltage
(Voltage that sounds an alarm)
The Speech function (ON/OFF)
Current receiver battery voltage
The minimum and maximum the
when powering ON are shown.
Alarm/vibrator ON/OFF and type set-
ting (The arrow indicates that an
alarm is generated when the power
supply voltage drops below the set
value.)
1
(Limit adjustment)
Select the setting item "Limit" by (JOG) button up, down, left or right operation.
Use the (+) or (-) button to adjust the limit voltage.
2
(Alarm and vibrator function setup)
Select the setting item "Alarm" by (JOG) button up, down, left or right operation. Set the
function to the active state by pressing the (+) or (-) button.
"Inhibit" :No audible alarm
"Buzzer" :Audible alarm
"Voice" :Voice alarm
Select the setting item "Vibrator" by (JOG) button up, down, left or right operation. Press the
(+) or (-) button and select the type.
"Inhibit" :No active vibration
"Type1" :Continuous vibration
"Type2" :Intermittent vibration for a long time
"Tyoe3" :Intermittent vibration for a short time
3
(Speech function setup)
Select the setting item "Voice" by (JOG) button up,
down, left or right operation. Set the function to the ac-
tive state by pressing the (+) or (-) button.
"OFF" :No voice guide
"ON" :Information loaded by voice
4
When ending setting, return to the Telemetry menu screen by pressing the (END) button.
Alarm and Vibrator function setup
Press
Press