Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 124)

MC940,960CR
124
Fu
n
c
tio
n
MC Link Function (ESC Link)
BEC voltage
MC940,960CR/ :6.0V/7.4V
Same as Link software BEC Volt.
The receiver BEC voltage can be selected from 6.0V and 7.4V. Match the volt-
age to the rating of the servo connected to the same receiver. This BEC voltage
cannot output a voltage higher than the input voltage.
For instance, if a 6.0V receiver and servo are used with a power supply voltage
of 7.4V or more, set the BEC voltage to 6.0V and when a high voltage receiver
and servo are used, set the BEC voltage to 7.4V.
Turbo mode
MC940,960CR/ :Turbo0/Turbo1/Turbo2
Same as Link software Turbo Mode.
This function sets the turbo mode. More power can be displayed by using the turbo mode. Depending on the set-
ting, the motor and ESC may be damaged so make this setting carefully.
(Note) When "Lead angle use" is INH, lead angle setting will not operate
even if set to "Turbo1" or "Turbo2." (Turbo mode disabled, Turbo0=Off)
-Turbo0 mode: (No Lead Angle mode) Lead angle - No
When used in races in which the lead angle setting function is inhibited by
ESC, set to this mode. The lead angle function is disabled the same as if
"Lead angle use" was turned off.
When the lead angle function was disabled by the method described above,
the MC940,960CR shows that the lead angle function is off by blinking a
blue LED at an ON 0.1 second, OFF 0.9 second cycle at the neutral point.
-Turbo1 turbo mode: (Lead Angle mode) Lead angle – Yes
The output can be increased by setting a lead angle.
Depending on the set value, the motor may be damaged so increase the lead angle value in steps from a small
value while observing the conditions.
Turn on "Lead angle use" and adjust the lead angle by "Lead angle" and point A, B, C, D, E (A, B, C, D, E Lead
angle) value.
-Turbo2 power mode: (Power Mode) Lead angle – Yes
Displays still more power than a turbo.
However, since even a motor applies a large load on the ESC, make the lead angle larger in steps from a small
value while observing the conditions.
Turn on "Lead angle use" and adjust the lead angle by "Lead angle" and point A, B, C, D, E (A, B, C, D, E Lead
angle) value.
Power point A
MC940,960CR/ :0rpm~100000rpm
Same as Link software Power Point A.
When the turbo mode is power 2 (Power mode) and the lead angle is large,
movement may become stiff when entering the course, etc. In this case, make
operation smooth by lowering the set speed at power point A.
This function is not performed in modes other than Turbo 2.