Edit network configuration page – Comtrol UP DeviceMaster User Guide User Manual
Page 82
82 - Chapter 3. Embedded Configuration Pages
DeviceMaster UP Modbus/TCP User Guide: 2000447 Rev. I
Edit Network Configuration Page
3.7. Edit Network Configuration Page
You can use the Edit Network Configuration page to change the DeviceMaster UP network configuration after
using PortVision DX for initial network configuration.
Use the following procedure to change the network configuration.
1.
Select the IP configuration type (DHCP or Static).
2.
If you select Static, enter a valid IP address, subnet mask, and IP gateway for your network. The network
information is programmed into the DeviceMaster UP after applying the changes and rebooting the
device. If necessary, see your network administrator for a valid IP address.
Note: The DeviceMaster UP family default IP address is 192.168.250.250, default subnet mask is
255.255.0.0, and the default IP gateway is 192.168.250.1.
3.
Select Save or Undo Changes to close the page.
4.
If you selected Save, select Reboot to program the network information into the DeviceMaster UP or
Continue if you want to reboot later.
Note: Changed network settings do not take affect until the DeviceMaster UP is rebooted.