Comtrol VS1100 Configuration Guide User Manual
Comtrol Accessories communication
This manual is related to the following products:
Table of contents
Document Outline
- InterChangeVS™ 1000 Series
- VS1000 and VS1100
- InterChangeVS™ 1000 Series
- VS1000 and VS1100
- Hardware
- Table of Contents
- List of Tables
- Introduction
- Installing the Hardware
- 1. Write down the serial number and Network (MAC) ...
- Table 2. VS1000 Model and Serial Numbers
- 2. Optionally, mount the VS1000 into the rack usin...
- 3. Connect an Ethernet cable from the appropriate ...
- 4. If not connecting VS1100 expansion units, put t...
- 5. Make sure the power switch is set to Off (0).
- 6. Connect the power cord to the unit and plug it ...
- 7. If you are installing VS1100 expansion units, c...
- 1. Record the serial numbers of the VS1100 units.
- Table 3. VS1100 Model and Serial Numbers
- 2. Optionally, mount the VS1000 into the rack usin...
- 3. Connect the VS1100 device or devices to the VS1...
- 4. Install the terminator plug in the OUTPUT conne...
- 5. Continue with the Power-On Diagnostics discussi...
- 1. All LEDs should light up briefly, to show that ...
- 2. Both 10Base-T lights should remain lit after th...
- 3. If using 10Base-T cabling, the lower LED remain...
- 4. The Port 1 LED begins flashing, to indicate tha...
- 5. The upper 10Base-T LED flashes briefly, as the ...
- 6. The port LEDs begin flashing in a “sweeping” se...
- Table 4. 10Base-T LED Descriptions
- Table 5. Ports 1 Through 16 LED Descriptions
- Building Cables
- InterChangeVS Specifications
- Notices
- Index