Configure and run the example rslogix 5 program – Comtrol UP DeviceMaster User Guide User Manual
Page 147
DeviceMaster UP EtherNet/IP User Guide: 2000424 Rev. L
Chapter 5. Programming the PLC - 147
Configure and Run the Example RSLogix 5 Program
5.5.9. Configure and Run the Example RSLogix 5 Program
You can configure and run the RSLogix 5 example programs through RSLogix 5. For additional information
on the RSLogix 5, see
5.5.10. RSLogix 5 Screen Examples
Note: The DeviceMaster UP must be configured for PLC-5/SLC before you can configure and download the
example RSLogix 5 program. For instructions on configuring DeviceMaster UP, see
DeviceMaster UP for the RSLogix 5 Program
, earlier in this section.
1.
Select the appropriate message type example programs (SLC or PLC-5) and copy the files (.PC5, .SY5 and
.SY6) to the desired directory.
2.
Start RSLogix 5 and open the .PC5 file.
3.
To modify the PLC program for your system, double-click Controller Properties.
4.
In the General tab, select your PLC-5 processor type
under Processor Type and provide a Processor Name.
5.
Select your PLC-5 series in the Series box and select
your firmware revision in the Revision box.
6.
Select the Controller Communications tab and select
the following options.
a.
Set Driver to the appropriate type to allow
RSLogix 5 to communicate with the PLC-5
processor.
b.
Type the processor node number in the Processor
Node box. (You may reference the Last Configured
(System) node or select Who Active.)
7.
Click OK to apply your changes and close the
Controller Properties dialog.
8.
Double-click I/O Configuration and verify your
chassis and PLC-5 type. If the chassis type is not
correct:
a.
Right-click the chassis type (for example, 1771-
A1B (4 Slots)) and select Properties.
b.
Select your chassis.
c.
Optionally, select the appropriate DIP switch
settings for your system from the DIP Switches
panel.
d.
Click OK to save settings.
9.
Click OK to save settings.