Comtrol UP DeviceMaster User Guide - Manual (Page 67)

DeviceMaster UP Modbus/TCP User Guide: 2000447 Rev. I Chapter 3. Embedded Configuration Pages- 67
Serial Device Configuration Page
3.3. Serial Device Configuration Page
The Serial Device Configuration page provides:
• Links to other pages
• Access to the Edit Serial Port Configuration
page for each port (Port #)
• An overview of serial device configuration
settings for each port displays the current
settings
To change these settings for a port, click the
corresponding Port # link, which opens the Edit
Serial Port Configuration page. See
3.3.1. Edit
Serial Port Configuration Page on Page 67 to
locate information for each setting area.
3.3.1. Edit Serial Port Configuration Page
Use the Edit Serial Port Configuration page to change a serial port’s configuration parameters.
To access the Edit Serial Port Configuration page, select the appropriate port number link (for example, Port
1) on the Serial Device Configuration page.
The next two subsections discuss the Serial Port and Serial Packet ID Settings areas on this page. The
remainder of the page is discussed in the following subsections, which are located under the 3.6. Common
Configuration Areas (Serial or Ethernet Device) section:
• 3.6.1. Ethernet/IP Settings on Page 75
• 3.6.2. Filtering/Data Extraction Configuration on Page 77
Ethernet Device
Configuration
Opens the Ethernet Device Configuration page ( 3.4. Ethernet Device Configuration
Page on Page 71), which provides an overview of the Ethernet device interface settings
and access to the Edit Socket Port Configuration page for Ethernet device
configuration on the selected socket port.
Communication
Statistics Opens the Communication Statistics page ( 4.1. Communication Statistics on Page
88), which contains the serial and Ethernet device interface statistics.
Display Serial Logs
Opens the Serial Interface Logs page (Page 94), which provides access to the receive
and transmit serial logs.
Display Ethernet
Device Logs Opens the Ethernet Device Interface Logs page (Page 95), which provides access to the
receive and transmit logs.
PLC Interface
Diagnostics
Opens the PLC Interface Diagnostics page ( 4.4. PLC Interface Diagnostics on Page
96), which contains the statistics and error reporting for the EtherNet/IP PLC
interface.
Configure Network
Opens the Configure Network page ( 3.7. Edit Network Configuration Page on Page
82), which can be used to modify DeviceMaster UP network configuration after initial
configuration using PortVision DX.
Configure Security
Opens the Edit Security Configuration page ( 3.8. Edit Security Configuration Page on
Page 83), which provides security configuration functionality for the DeviceMaster
UP.
Reboot
Reboots the DeviceMaster UP.
Note: The Reboot option also provides an option to reset the ports to factory defaults.
Server Configuration Page (Continued)