Rslogix 500 screen examples - slc plc, Setting up processor and ethernet (channel 1) – Comtrol UP DeviceMaster User Guide User Manual
Page 123
DeviceMaster UP EtherNet/IP User Guide: 2000424 Rev. L
Chapter 5. Programming the PLC - 123
RSLogix 500 Screen Examples - SLC PLC
5.4.6. RSLogix 500 Screen Examples - SLC PLC
The following subsections explain how to configure the DeviceMaster UP through RSLogix 500. Use the
screens to set up the PLC and program the various messages.
5.4.6.1. Setting up Processor and Ethernet (Channel 1)
You must set up the Processor and Ethernet communication port properly for EtherNet/IP to function. Read
the information and follow the procedures provided in the following Rockwell documents:
•
SLC 5/03, 5/04 and 5/05 Modular Processors Installation Instructions (publication 1747-IN009D-MU-P)
•
SLC 500 Instruction Set (publication 1747-RM001D-EN-P, pages 13-22 through 13-47).
The following screens show the recommended settings that allow EtherNet/IP to function properly on an SLC
or MicroLogix PLC.
1.
Start RSLogix 500.
2.
Double-click Controller Properties and select the
correct processor type from the General tab on
the Controller Properties dialog.
3.
Select the Controller Communications tab and
select the proper driver for RSLogix 500.
4.
Click OK to apply your changes and close the Controller Properties dialog.