Cabletron Systems HSIM-W6 User Manual
Page 79
Chapter 6: HSIM-W6 Configuration with QuickSET
HSIM-W6 User’s Guide
65
The following definitions explain the fields in the System Passwords window shown in
Read Only Access —
This access level allows reading of device parameters not including
system passwords. Place the cursor in this field and type in the new system password. Retype the
system password in the Confirm Password field below the Read Only Access field.
Read/Write Access —
This access level allows editing of some device configuration parameters
but not including changing system passwords. Place the cursor in this field and type in the new
system password. Retype the system password in the Confirm Password field below the Read/
Write Access field.
QuickSET (SuperUser) —
This access level allows full management privileges. Place the cursor
in this field and type in the new system password. Retype the system password in the Confirm
Password field below the QuickSET (SuperUser) field.
When finished configuring the HSIM-W6 system passwords, click on the OK button in the System
Passwords window to return to the HSIM configuration window.
Once the IP address configuration is complete, click on the Next>> button in the HSIM
configuration window and proceed to the section,
Wide Area 1 and 2 Configuration
.
!
CAUTION
If you edit the super-user system password, be certain you do not forget it. If you do, you
will be unable to perform management functions without returning the device to its
factory default configuration. This will effectively erase any configuration work you may
have done.