Cabletron Systems HSIM-W6 - Manual (Page 33)

Chapter 2: About the HSIM-W6
HSIM-W6 User’s Guide 19
read-write — This access level allows editing of some device configuration parameters not
including changing system passwords.
super-user — This access level allows full management privileges, allowing you access to
QuickSET.
Simple Network Management Protocol (SNMP)
The HSIM-W6 provides SNMP agent support for the following: standard and Enterprise Specific
Management Information Bases (MIBs), and support for standard and Enterprise Specific SNMP
Traps. SNMP is also used internally for configuration of the HSIM-W6. The active SNMP agent
within the HSIM-W6 accepts SNMP requests for status, statistics and configuration updates.
Communication with the SNMP agent occurs over the LAN or WAN connection. Any
management application using SNMP over
UDP/IP has access to the local SNMP agent.
SNMP MIB Support
SNMP MIBs are databases of objects used for managing and determining the status and
configuration of an SNMP compliant device.
The following SNMP MIBs are supported by the HSIM-W6:
• MIB IIRFC1213
• RMON MIBRFC1271
• DS1 and E1 MIBRFC1406(Digital Signal Level 1 [T1/E1 interface types])
• IETF Bridge MIBRFC1493
• IP Forwarding MIBRFC1354
• PPP LCP MIBRFC1471(Point-to-Point Protocol, Link Control Protocol)
• PPP IPCP MIBRFC1473(IP Control Protocol)
• PPP BNCP MIBRFC1474(Bridge Network Control Protocol)
• IPXCP MIBRFC1552(PPP Internetworking Packet Exchange Control Protocol)
• Frame Relay DTE MIBRFC1315
• Security MIBRFC1472(CCP, PAP, and CHAP)
• RS-232 MIBRFC1317
• LQM MIBRFC1989
• PPP MPRFC1990