Cabletron Systems HSIM-W6 - Manual (Page 159)

Chapter 7: General Configuration Using Local Management
HSIM-W6 User’s Guide 145
AdminStatusTime — Displays the amount of time elapsed since an IP address was assigned to
the HSIM-W6.
UDP Type — Displays the User Datagram Protocol (UDP) Service to which the selected UDP
Port number corresponds.
Description — Describes the selected port.
MAC Address — Displays the physical (MAC) address of the HSIM-W6.
Interf. Type — Displays the type of interface used by the specified port.
Oper Status — Displays the operational status of the selected port.
IP General Configuration Fields
This section provides a general overview of the procedures required to configure the HSIM-W6.
The following list describes each of the IP General Config Screen fields.
+PORT- — Use this field to select the routing port you wish to configure.
+REDIRECTOR- — Use this field to toggle through a list of commonly used UDP port numbers.
UDP port numbers are associated with the relay agent functionality of the router.
Framing — Use this field to select the format of the frame in which IP packets are encapsulated
for transmission.
MTU — Use this field to set the Maximum Transmission Unit (MTU).
IP Routing — Use this field to enable IP Routing Services.
IP Forwarding — Use this field to enable IP Forwarding.
Proxy ARP — Use this field to enable Proxy Address Resolution Protocol (ARP).
Address — Use this field to assign an IP address to the port that you wish to configure.
Mask — Use this field to set the subnet mask for the port that you wish to configure.
UDP Port — Use this field to select a UDP port number for network service requests.
Network Bcast — Use this field to send network broadcasts addressed to all 0’s.