Cabletron Systems HSIM-W6 - Manual (Page 175)

Chapter 7: General Configuration Using Local Management
HSIM-W6 User’s Guide 161
To enable SAP Routing, complete the following steps:
1. From the IPX Configuration screen, highlight IPX SAP and then press ENTER.
The IPX SAP SETUP screen, shown in Figure 66 , displays.
2. Use the arrow keys to highlight the Port field.
3. Type in the number of the port that you wish to enable SAP routing, then press ENTER.
4. Use the arrow keys to highlight the Port Level SAP field.
5. Use the ENTER key to toggle the entry to ENABLED.
6. Use the arrow keys to highlight the SAVE command at the bottom of the screen, and then press
ENTER. The message “SAVED OK” displays.
Figure 66 IPX SAP Configuration Screen
System Level SAP:
Port Level SAP:
RETURN SAVE +PORT-
DISABLED
DISABLED
IPX Address: xxx.xxx.xxx.xxx
Port: 1
HSIM-W6 Local Management Flash Image Version XX.XX.XX
IPX SAP CONFIGURATION