Cabletron Systems HSIM-W6 - Manual (Page 153)

Chapter 7: General Configuration Using Local Management
HSIM-W6 User’s Guide 139
Bridge Setup Screen
The Bridge Setup screen enables you to select a Spanning Tree protocol and enable/disable bridge
ports.
Access the Bridge Setup screen, shown in Figure 58 , by using the arrow keys to highlight the
Bridge Setup option and pressing ENTER. The Bridge Setup screen displays.
Figure 58 The Bridge Setup Screen
Bridge Setup Screen Fields
The following list describes each of the Bridge Setup screen fields:
Spanning Tree Protocol — Use this field to select a Spanning Tree protocol. Possible selections
for this field are IEEE 802.1, DEC, or NONE.
Bridge Port Admin Status — Use this field to enable or disable individual HSIM-W6 bridge
ports. Possible selections for this field are ENABLED or DISABLED.
Bridge Port Pair Admin Status — Use this field to enable or disable bridging between bridge
port pairs. For example, you can enable Port 1 to bridge traffic to all ports except Port 2.
BRIDGE SETUP
SPANNING TREE PROTOCOL:
BRIDGE PORT ADMIN STATUS:
BRIDGE PORT PAIR ADMIN STATUS:
SAVE
[IEEE 802.1]
PORT 01 --> ALL PORTS
PORT XX --> PORT [02]
BRIDGE_PORT [01] RETURN
[ENABLED]
[ENABLED]
2012_08
HSIM-W6 Local Management Flash Image Version: XX.XX.XX