Cabletron Systems HSIM-W6 - Manual (Page 186)

Chapter 8: MIB Navigator
172 HSIM-W6 User’s Guide
Other Commands — Other commands allow you to access and manage network devices
connected to the device running the MIB Navigator. The commands are as follows:
Special Commands — Special Commands allow you to exit from the MIB Navigator. The
commands are as follows:
Conventions for MIB Navigator Commands
This manual uses the following conventions for denoting commands:
• Information keyed by the user is shown in this helvetica font.
• Command arguments are indicated by two types of brackets:
- required arguments are enclosed by [ ].
- optional arguments are enclosed by < >.
MIB Navigator command conventions are as follows:
• To abort the output or interrupt a process the escape character is ^C (where ^ indicates the
Control key).
• A slash (/) preceding an OID issues that command from the root directory regardless of where
you are in the MIB. If no slash precedes the OID the command issues from your current MIB
location.
• Dot notation (1.1.1.1) is equivalent to slash notation (1/1/1/1). Use slash notation with the
navigational commands, and the dot notation with the built-in commands that are using SNMP
to access and manage network devices.
arp bridge circuitmap defroute
dhcp imux nat netstat
ping ppp reset route
secondIP show snmpbranch snmpget
snmpnext snmpset snmptree traceroute
done quit exit