Cabletron Systems HSIM-W6 User Manual
Page 67
Chapter 5: Installation
HSIM-W6 User’s Guide 53
3.
Install the CSX-COMP/ENCR in the HSIM-W6 by unlocking the top and bottom plastic
locking tabs of the module faceplate. Slide out the module and place it on its side with the
internal components facing up.
4.
Locate the D-Type connector and the standoffs on the HSIM-W6 (refer to
5.
The D-Type connector pins of the CSX-COMP/ENCR only fits one way onto the HSIM-W6
D-Type connector. Lower the CSX-COMP/ENCR onto the standoffs and align the connector
with the connector pins. Carefully insert the connector pins of the CSX-COMP/ENCR into the
connector on the HSIM-W6.
6.
Press down firmly on the CSX-COMP/ENCR until the pins fit all the way into the connector.
7.
Secure the CSX-COMP/ENCR with the standoff screws supplied with the CSX-COMP/ENCR.
The CSX-COMP/ENCR installation is complete.
Figure 13
CSX-COMP/ENCR
NOTE
Ensure that the CSX-COMP/ENCR is aligned such that its connector pins correctly align
with the D-Type connector on the HSIM-W6.
Standoff Screws
Standoff
D-Type
Connector
CSX-COMP/ENCR
D-Type
Connector Pins
Detail
2204N01