Cabletron Systems HSIM-W6 - Manual (Page 115)

Chapter 6: HSIM-W6 Configuration with QuickSET
HSIM-W6 User’s Guide 101
Advanced IP Routing Settings
This section describes the fields for the Advanced IP Routing Settings of the Advanced Routing
configuration window.
Interface # — Displays the active interface number.
Local WAN IP Address — Set this value only if you are going to use Numbered mode. In
Numbered mode, the Local WAN IP address is the IP address of the WAN link leading to the Telco
Cloud. A subnet mask for this IP address is required before you can use this link.
Subnet Mask — Displays the subnet mask for the Local WAN IP address.
Modify — Use this button to change an entry in the Advanced IP Routing Settings section. Select
the interface number to modify by clicking on the tab to the left of the interface number.
Advanced IP Routing Options
This section describes the fields for the Advanced IP Routing Options of the Advanced Routing
configuration window.
Enable RIP — Selecting this function enables the sending and receiving of Routing Information
Protocol packets. Routing Information Protocol is used in IP for broadcasting open path
information between routers to keep routing tables current.
Redirector Window
The Redirector window shown in Figure 38 displays after clicking on the Redirector... button in
the Advanced Routing configuration window. The Redirector window is used to set up an IP
address for a remote Dynamic Host Configuration Protocol (DHCP) server.
Figure 38 Redirector Window