Cabletron Systems HSIM-W6 - Manual (Page 166)

Chapter 7: General Configuration Using Local Management
152 HSIM-W6 User’s Guide
To enable RIP , complete the following steps:
1. From the IP Configuration screen, highlight IP RIP and then press ENTER.
The IP RIP CONFIGURATION screen, shown in Figure 62 , displays.
2. Use the arrow keys to highlight the System Level RIP-1 field.
3. Use the ENTER key to toggle the entry to ENABLED.
4. Use the arrow keys to highlight the Port Level RIP-1 field.
5. Use the ENTER key to toggle the entry to ENABLED.
6. Use the arrow keys to highlight the SAVE command at the bottom of the screen, and then press
ENTER. The message “SAVED OK” displays.
Figure 62 IP RIP Configuration Screen
IP RIP CONFIGURATION
System Level RIP-1:
Port Level RIP-1:
RETURN SAVE +PORT-
DISABLED
DISABLED
IP Address: xxx.xxx.xxx.xxx
Port: 1
HSIM-W6 Local Management Flash Image Version XX.XX.XX