Canon mx860 - Manual (Page 714)

page. Divide the document or set the image
quality (Fax resolution) to a lower setting, then
resend it.
#005 No answer. The recipient's fax machine does not respond.
Contact the recipient and have the recipient
check that the telephone line is connected
correctly.
#012 Try again. There is no paper in the recipient's fax
machine.
Contact the recipient and have the recipient
load paper.
#017 No tone is detected. The machine could not detect the dial tone.
Dial tone detect in Transmission settings is set
to ON. Set it to OFF, then send the fax.
#018 Line was busy. The fax/telephone number you dialed is busy.
Try dialing again after waiting for a moment.
#022 Try again. The fax/telephone number registered to the
speed dial is incorrect.
Check the recipient's fax/telephone number,
correct the fax/telephone number registered to
the speed dial code, then send the document
again.
#037 Memory is full. The machine could not send a document
because its memory is full.
Resend the document after deleting contents
in memory. See
Deleting a Document in
Memory .
#059 Transmission has been
canceled due to a fax
information mismatch.
Transmission has been canceled because the
machine could not detect the recipient's fax
machine information or the information did not
match the dialed number. This error number is
displayed when Check RX fax info is set to ON.
For details, see
Sending Faxes after Checking
Information (Checking the Recipient's
Information)
.
#085 Try again in black & white
transmission.
The recipient's fax machine is not color-
compatible.
Resend the document in black & white.
STOP The Stop button was
pressed during
transmission.
The Stop button was pressed to cancel
transmission of the document. Resend it if
necessary.
RX Report
This machine can print a RX (reception) report after receiving a document, confirming whether the
reception has been completed successfully. At the time of purchase, the machine is set so that RX
reports are not printed at all. You can set the machine to print a report each time it receives a
document, or only when an error occurs.
Note
For details on the RX report settings, see RX report .
For the errors when you receive a fax, see Errors when you receive a fax .
Errors when you receive a fax
If an error occurs when you receive a fax, the error number is printed in the RX report (there are
some errors for which the cause is also printed).
The causes corresponding to the error numbers are as follows.
No. Cause Action
#003 It takes too long to receive a Contact the sender and have the sender divide
Page 714 of 997 pages Summary of Reports and Lists