Canon mx860 - Manual (Page 4)

cleaning the machine.
If you accidentally switch the machine on while cleaning it, you could
injure yourself or damage the machine.
Maintaining
the machine Do not attempt to disassemble or modify the machine. There
are no user serviceable parts inside the machine.
The machine contains high-voltage components. Never attempt any
maintenance procedure not described in this guide.
Do not connect other than recommended devices to the Direct
Print Port or cable connector on the machine. It could cause a
fire or electric shock.
Working
around the
machine Do not use highly flammable sprays near the machine.
This could cause a fire or electric shock if the spray comes into contact
with electrical components inside the machine.
Caution
The following are instructions that, if ignored, could result in personal injury or material damage
caused by incorrect operation of the equipment. These must be observed for safe operation.
Choosing a
location Do not install the machine in a location that is unstable or
subject to excessive vibration.
Do not install the machine in locations that are very humid or
dusty, in direct sunlight, outdoors, or close to a heating
source.
To avoid the risk of fire or electric shocks, install the machine
in a location with an ambient temperature range of 5°C to 35°C
(41°F to 95°F) and humidity of 10% to 90% (condensation free).
Do not place the machine on a thick rug or carpet.
Do not place the machine with its back attached to the wall.
Power supply Ensure that the area around the
power outlet is kept clear at all times
so you can easily unplug the power
cord if necessary.
Never remove the plug by pulling on
the cord.
Do not use an extension lead/cord.
Working
around the
machine Never put your hands or fingers in the machine while it is
printing.
When moving the machine, carry the machine at both ends.
Do not hold the Operation Panel.
Do not place any object on the machine.
Do not place metal objects (paper clips, staples, etc.) or
containers of flammable solvents (alcohol, thinners, etc.) on
top of the machine.
If any foreign object (metal or liquid) fall into the machine,
unplug the power cord and call for service.
Page 4 of 997 pages Safety Precautions