Canon mx860 - Manual (Page 593)

Note
If you scan without preview, colors are adjusted based on the document type selected in Select
Source.
4. Set Destination.
5. Set Output Size.
Output size options vary by the items selected in Select Source and Destination.
6. Adjust the scan area (cropping frame) as required.
Adjust the size and position of the scan area (cropping frame) on the preview image. You can also
create two or more cropping frames.
If an area is not specified, the document will be scanned at the document size (Auto Crop). If an area
is specified, only the portion in the specified area will be scanned.
Adjusting Cropping Frames
7. Set Image corrections as required.
8. Click Scan.
Scanning starts.
Note
Click (Information) to open a dialog box in which you can check the current scan settings
(document type, etc.).
ScanGear's response after scanning can be specified in Status of ScanGear dialog after scanning
on the Scan tab of the Preferences dialog box.
Scan Tab
Related Topic
Basic Mode Tab
Page top
Page 593 of 997 pages Scanning in Basic Mode