ADS Environmental Services FlowShark QR 775003 A2 - Manual (Page 201)

8-16 ADS FlowShark IS Manual
5. Carefully disconnect the black (power) and the ribbon
(communication) cables from the back of the modem.
6. Slide the existing modem out of the bracket, and insert the new
modem into the bracket.
7. Connect the black and the ribbon cables to appropriate ports on
the back of the new modem.
8. Reattach the modem bracket to the back panel of the EMU
without pinching the cables behind the bracket.
9. Insert a new SIM card or the SIM card from the original
modem into the slot on the new modem. Refer to the next
section, Replacing the SIM Card in the EMU Modem, for
instructions on removing an existing SIM from a modem and
inserting a new SIM card into the modem.
10. Restore power to the EMU.
11. Enter or confirm the correct IP address in Profile, and have a
data analyst attempt to contact to the monitor remotely to verify
communications.
12. Replace the cover on the EMU and tighten the four plastic
screws, provided all EMU maintenance is complete.
Replacing the SIM Card in the EMU Modem
Replace the SIM card in the modem in the following way:
1. Disconnect the power (battery or external) running to the
EMU/modem.
2. Slide the lock on the front of the modem holding in the SIM
card to the right.
3. Gently press in on the SIM card to release it from the socket.
Upon release, it should slide out slightly from the socket.
4. Remove the SIM card from the modem socket.
5. Write down the IP address for the new SIM card, and then
insert the new card completely into the socket in the front of the
modem.