ADS Environmental Services FlowShark QR 775003 A2 - Manual (Page 104)

4-1
C H A P T E R 4
Communication
After installing the sensors in the pipe and connecting the sensors to
the ADS ® FlowShark ® IS monitor, it is necessary to establish
communication with the monitor (through telemetry or direct
connection). This chapter contains instructions on establishing a
wireless connection for communicating with the monitor remotely
or using a special cable to connect directly to the monitor on site.
Note:
Manhole and sewer system work involves confined
space entry and is inherently dangerous. Therefore,
installers and technicians must comply with all federal,
state, and municipal regulations concerning confined space
entry. ADS is not responsible for any injuries, damages,
claims, or liability resulting directly or indirectly from the
use of this installation guide or the installation of any ADS
equipment.
Note:
ADS wireless communication products (in this
case, the Enfora ™ modem in the EMU) use static IP
address network services provided by AT&T ™ (formerly
Cingular Wireless). Therefore, any installation location
designated for wireless communication must have access to
AT&T 850 or 1900 MHz service. Each wireless device
must be fitted with a SIM (Subscriber Identity Module)
card that is provisioned by AT&T with specific account
and network information for use with ADS software.