ADS Environmental Services FlowShark QR 775003 A2 - Manual (Page 142)

Configuration and Activation 6-13
device in the Monitoring Point Devices section to ensure
Profile
includes the device in the LIF. Deselect the checkboxes
from the Available Devices section corresponding to the
devices you do not want to include as associated with the
selected monitoring point in the LIF.
Note: Profile selects the Ultrasonic 1, Velocity 1,
Pressure 1, and MLI ® 1 devices for the FlowShark IS flow
monitor by default. The MLI device is not specifically
associated with a sensor. It represents special software
included in the monitor firmware that supports activities
such as water quality sampling and event notification.
The selected devices display in the Monitoring Point Devices
section.
6. Repeat steps 4 through 5 to assign devices to Monitoring
Point 2, when applicable.
7. As necessary, edit the parameters specific to each device in the
following way:

Access the device parameters by selecting (highlighting)
the device you want to edit in the Monitoring Point
Devices
section and then clicking on the Edit button.
 Refer to the following sections for details concerning the
specific device parameters.
8. Once you have edited the devices as necessary, click on the
OK
button to save the devices to the LIF.