ADS Environmental Services FlowShark QR 775003 A2 - Manual (Page 10)

1-4 ADS FlowShark IS Manual
Note:
A legacy Rechargeable Battery Pack (RBP) may be
connected to the COMM connector on the FlowShark IS
in a similar manner as it is connected to the ADS Model
3600  flow monitor.
Telemetry
Only the Wireless External Modem Unit (EMU) (ADS p/n 3800-
0148 or 3800-148EP) is approved for connection to the FlowShark
IS. The EMU provides wireless telemetry via a quad-band
GSM/GPRS modem that is isolated and mounted in an enclosure
outside the hazardous area. The EMU connects to the FlowShark IS
via an approved Communication Cable (ADS p/n 106227A-xxx,
where xxx represents the length of the cable) that is direct-buried or
enclosed in conduit per local regulations.
Note: ADS wireless communication products (in this
case, the GSM/GPRS modem in the EMU) use static IP
address network services provided by AT&T (formerly
Cingular Wireless
). Therefore, any installation location
designated for wireless communication must have access to
AT&T 850 or 1900 MHz service. Each wireless device
will be fitted with a SIM (Subscriber Identity Module) card
that is provisioned by AT&T with specific account and
network information for use with ADS software.
Additional Features
Special features of the FlowShark IS flow monitor include the
following.

All monitors are checked carefully before being shipped. Each
component is guaranteed to meet specifications. Internal quality
inspectors complete the pre-shipping inspection.

All monitors connect to existing ADS IS 106 series sensors.
The female connector is located on the flow monitor chassis;
the male connector is located on the sensor cable (unlike other
ADS monitors
). This arrangement of connectors prevents
mismatching with non-IS sensors.