ADS Environmental Services FlowShark QR 775003 A2 - Manual (Page 115)

4-12 ADS FlowShark IS Manual
5. Terminate the 12 wires into the orange connector in the
following way using the ⅛-inch flat screwdriver. This
information also displays on a label affixed to the inside cover
of EMU box. Make sure all screws are tight.
Terminal Color of Wire
1 Yellow
2 Small Blue
3 Small Black
4 White
5 Small Red
6 Small Green
7 Brown
8 Orange
9 Large Red
10 Large Blue
11 Large Black
12 Large Green with Bare
Shield drain wire
Note:
The wires can become loose while moving the
cable. Therefore, after terminating the wires, verify once
again that each wire is secure.
6. Plug the connector into the corresponding port on the black
Communication Interface/Barrier Box, and then pull back the
excess cable from outside of the EMU.
Note: The port on the Communication Interface/Barrier
Box may be difficult to access because of the close
proximity of other components, such as the bracket holding
the modem. Therefore, it may be necessary to remove the
box from the EMU before attaching the orange connector.
Release the box from the back plate of the EMU by
grasping the rear edge of the box (next to the back plate)
and gently, but firmly, pulling to release the Velcro ® grips.
After seating the orange connector, verify that all
connections to the Communication Interface/ Barrier Box
are secure and reseat the box onto the Velcro.