ADS Environmental Services FlowShark QR 775003 A2 - Manual (Page 187)

8-2 ADS FlowShark IS Manual
Maintaining the System Components
The FlowShark IS flow monitor and sensors should receive routine
on-site inspections and remote confidence checks to maintain the
equipment in optimal working condition, minimize monitor
downtime, and prevent possible data loss.
ADS recommends performing these inspections following initial
system installation, during site visits, and on a scheduled interval
(i.e., quarterly or during battery pack replacement).
Note:
The only service or maintenance activity ADS
permits within the monitor chassis is battery pack
replacement. Therefore, do not handle, alter, modify,
remove, or replace any other components inside the
monitor. Such actions will void the monitor warranty
agreement and the IS certification.
Gathering Replacement Parts and Supplies
Gather the following replacement parts and supplies for performing
routine maintenance:

Dryer tube for the pressure depth sensor

Battery packs for both the EMU and the FlowShark IS monitor

IS ultrasonic depth, pressure depth, and Doppler velocity
sensors

Soft bristle brush

Paper towels

Compressed air

Flat head screwdriver and assorted wrenches