Banner PresencePLUS P4 COLOR Series - Manual (Page 79)

Select the state (open or closed) that the output will take when not active. Normally Open/Closed
• Normally Open: The output becomes active when the logic condition controlling the
output becomes True.
• Normally Closed: The output becomes inactive when the logic condition controlling
the output becomes True.
Output Delay is the time from a trigger to start an inspection until the Sensor output turns ON.
It is available only for general outputs. Output Delay
Note: If processing time is longer than the output delay, the output will become active
immediately after the processing is finished.
This option is available only for the general outputs; the other outputs (Pass, Fail, System Error, and
Ready) are latched only. Output
Duration
• Latched: Active until the condition changes.
• Time: Active for a specific length of time.
ON
OFF
OFF
ON
Trigger
Output
Output Duration Processing Time
Delay Latched
Input/Ouput Tab
P4 Input/Output Tab
79 Minneapolis, MN USA Banner Engineering Corp.
System Setup Dialog 2/2010