4 bead tool – Banner PresencePLUS P4 COLOR Series User Manual
Page 200
7.5.4 Bead Tool
The Bead tool is used to inspect parts on which an application of adhesives or sealant material has been placed. In an
industrial setting, this "bead" of material is commonly applied in a strip on a known path. The Bead tool can look at
this pre-defined path and verify whether the adhesive or sealant has been correctly applied.
For the purposes of this tool, a bead is any long, narrow strip of approximate consistent width and approximately
consistent color. The bead must have sufficient contrast with its background so that a simple grayscale thresholding
scheme, like that used in the Blob Tool, can separate the two. Background clutter and optical noise (i.e. shiny spots,
holes in the bead) are permitted, but their presence may degrade the robustness of a bead inspection.
The Bead Tool also assumes that the bead material has been applied by a mechanized system and thus is quite consistent
in location and direction. The tool does not attempt to detect, follow, or account for variations in bead location.
Usage
• Check for uniformity of a bead of adhesive.
• Check for the uniformity of a gap.
Fields
The following are fields on the Bead tool Input tab:
•
on page 201
•
on page 203
•
on page 203
•
on page 205
•
on page 205
Supported Platforms
BCR/BCR
1.3
GEO/GEO
1.3
EDGE/EDGE
1.3
AREA/AREA1.3
OMNI/OMNI
1.3
OMNI
Color
ProII/ProII
1.3
ProII Color
No
No
No
No
Yes
Yes
Yes
Yes
Bead Tool Input Tab
Banner Engineering Corp.
Minneapolis, MN USA
200
2/2010
PresencePLUS Software Tools