Banner PresencePLUS Lighting User Manual
Specifications

LEDRR70X70-78587 Ring Light
High-Intensity LED Ring Light for use with
Printed in USA
Nov 2012
P/N 134088 Rev. C
• Integrates directly to Fanuc Robotics IRVision
• Compact ring light includes bracket that directly mounts to a SONY XC-56 camera
• Four extremely bright LEDs for illumination of targets beyond two meters
• Continuous or strobed operation
• Dual intensity control: pot and analog wire
• Maintenance-free, rugged construction
Ring Light Wire
External Power Supply
Brown
+24V dc
Blue
dc common
White
+24V dc (strobe)
Black
dc common (strobe)
Gray
0–10V dc Intensity control
Specifications
Light Source. Four visible red (627 nm) high-intensity LEDs
Illumination. 610 mm (24”) diameter usable light pattern at 1 m
Strobe. Optically isolated; active low
Supply Voltage and Current
Operating Voltage: 24V dc ±10%
Strobe Voltage: 5–24V dc at 10 mA maximum
Current Draw at Full Intensity: 350 mA max
Intensity Control Voltage: 0–10V dc
Built-in constant current regulator for LEDs
Dual Intensity Control
Potentiometer and analog wire: pot controls maximum intensity; analog
wire controls intensity from maximum brightness
(0V dc ) to dark (10V dc) at 10 mA max
Connections
200 mm (8 inches) integral pigtail with 5-pin male Euro-style connector
Construction
Enclosure rating: IP50
Housing: aluminum, black anodized
Window: acrylic, clear with frosted diffusing surface on inside
Bracket: CR steel, black. Attaches ring light directly to camera with two
screws (included with light)
Useful Life
50,000 hours (LED ON time)
When operated within specifications, output will decrease less than
30% after 50,000 hours.
Operating Conditions
Temperature: 0° to +50° C (+32° to 122° F)
Relative humidity: 90% (non-condensing)
Certification