beautypg.com

Banner PresencePLUS Lighting User Manual

Ledrpfk90 sealed ring light polarizing filter kit, Installing the polarizing filter kit

background image

Printed in USA

12/06

P/N 129871

Installing the Polarizing Filter Kit

The LEDRPFK90 Polarizing Filter Kit provides polarizing filters for both the light sources

and PresencePLUS camera.

1. If the ring light is installed on the camera, unscrew the ring light from the camera.
2. Remove the protective covering from both sides of each camera filter to be used.
NOTE: Take care not to fingerprint the filters. If necessary, carefully clean the filters

using only lens or window cleaner.

3. Remove the lens and insert the colored filter first, then the polarizing filter. Install

the retaining ring, using the tool supplied with the filter kit as shown in Figure 1.

NOTE: Both camera filters install behind the lens and are shaped to fit in only one

direction.

4. Screw the ring light back onto the camera, make sure the ring light is completely

threaded on the camera, loosen the set screw and rotate the cable outlet to the

desired position as shown in Figure 2.

5. Tighten the set screw.
6. To ensure correct alignment of the polarizing planes, the ring light filter must be

installed with the bump on the “top (label)” side of the camera, as it is shown in

Figure 2.

NOTE: If necessary, carefully clean the ring light window using only lens or window

cleaner.

7. Remove only the clear protective plastic covering from the filter.
CAUTION: Take care not to fingerprint the sticky side of filter, as those fingerprints

can not be removed.

8. Place sticky side of filter on the ring light; carefully press the filter, adhering it to the

window.

9. Remove the remaining protective covering from the filter.

10. Reinstall lens.

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: [email protected]

Red, Green,
or Blue Filter
and
Polarizing
Filter

Retainer Ring

Retainer Ring Tool

Figure 1. Installing the Colored Filter and Polarizing Filter “A” on the

Camera

Figure 2. Installing the Polarizing Filter “B” on the Ring Light

For use with PresencePLUS

®

and LED..R90S.. Light Source

LEDRPFK90 Sealed Ring Light Polarizing Filter Kit

Set Screw

Cable Outlet

Bump

Camera

Camera and Ringlight

Front View

Camera and Ring Light

Side View

View shown

without lens installed

Polarizing

Filter

Label