Rockwell Automation 1398-DDM-xxx ULTRA 100 Series Drives Installation Manual - Manual (Page 48)

Publication 1398-5.2 – PDF 1997
Chapter 4
ULTRA Master Installation
Chapter 4
Installation of ULTRA Master on a PC is covered in this chapter,
which:
●
Lists the minimum PC hardware and software necessary to run
ULTRA Master.
●
Provides step-by-step instructions on how to load ULTRA Master.
●
Shows you how to start and quit ULTRA Master and introduces
the Drive Window,
the main command window for ULTRA Master.
●
Instructs you on how to access on-line help.
Instructions for using the features available in ULTRA Master are
detailed in on-line help. To access the Help menu, depress the
F1 key.
Hardware and Software
Requirements
The minimum personal computer (PC) requirements to run the
software are:
●
A DOS computer with a 286 microprocessor
●
A hard disk, with 2.0 MB of free disk space
●
3½ inch, 1.44MB floppy disk drive
●
2 MB of RAM
●
A Video Graphics Array (VGA) monitor
●
Microsoft Windows version 3.1
●
A mouse is recommended.
Windows must be installed on your PC. If Windows is not already
installed, refer to the appropriate Microsoft manual to install Windows
on your computer.
Installing ULTRA Master To install ULTRA Master software on a hard drive:
1. Make a backup copy of the ULTRA Master disk in one of the fol-
lowing ways:
• Copy the ULTRA Master disk using the disk menu in the
Windows File Manager.
• If your computer has only one floppy disk drive, type from the
DOS command line prompt diskcopy a: b: and then
press ENTER . The software will prompt you when to insert the
SOURCE (ULTRA Master) disk and when to insert the TAR-
GET (blank) disk.