Rockwell Automation 1398-DDM-xxx ULTRA 100 Series Drives Installation Manual - Manual (Page 203)

Publication 1398-5.2 – PDF 1997
Appendix B
Cable Diagrams, Schematics and
Examples
Appendix B
Factory supplied cables allow ULTRA 100 Series drives to conform to
the European Union Directives when connecting the drive to motors,
controllers or computers. The following diagrams provide information
on the cables available from the factory.
Refer to Appendix A, “Options and Accessories” for ordering
information.
The information below applies to all factory supplied cables.
● Wire Insulation Type: Polyvinyl Chloride
●
Conductor size: 0.08 mm
2
(28 AWG) tinned copper, except as
noted below.
[0.25 mm
2
(24 AWG) on 9101-1372, 9101-1374 and 9101-1379]
[1.5 mm
2
(16 AWG) on 9101-1190, 9101-1381, 9101-1385 and
9101-1467]
[2.5 mm
2
(14 AWG) on 9101-1191 and 9101-1382]
[6 mm
2
(10 AWG) on 9101-1192 and 9101-1383]
[10 mm
2
(8 AWG) on 9101-1384 and 9101-1399]
[16 mm
2
(6 AWG) on 9101-1193]
●
Braid Shield Coverage: 85% minimum
●
Jacket Material: Thermoplastic elastomer
●
Moldings: 105°C (221°F) Black PVC
●
Minimum Bend Radius
Control Cables Motor Power Cables
Connector mm (in.) Cable mm (in.)
Controller (J1) 171.45 (6.75) 9101-1190 91.70 (3.6)
Encoder (J2) 129.54 (5.10) 9101-1191 98.80 (3.9)
9101-1192 156.00 (6.1)
9101-1193 226.80 ( 8.9)
9101-1381 91.70 (3.6)
9101-1382 98.80 (3.9)
9101-1383 156.00 (6.1)
9101-1384 226.80 ( 8.9)
9101-1385 106.70 (4.2)
9101-1399 189.25 (7.5)
9101-1467 91.70 (3.6)