Rockwell Automation 1398-DDM-xxx ULTRA 100 Series Drives Installation Manual - Manual (Page 235)

Publication 1398-5.2 – PDF 1997
TouchPad Instructions C-3
TouchPad Commands
Commands are entered by pressing a single key or combination of
keys. Two modes of operation are available. Parameter mode allows
you to move through the TouchPad Command Tree to each parameter.
Modify mode allows you to monitor and change each parameter, often
while the drive is operational.
The Parameter mode displays for the TouchPad Command Tree are
depicted on the “Supplemental Instructions” on page C-6.
Key Function
Mode/Enter
Toggles the parameter display between the two operating modes.
Parameter mode shows the abbreviated command name of the selected
parameter. Refer to the TouchPad Command Tree Chart for a full text definition.
Modify mode shows the setting, often a number, for the selected parameter.
Key functions in each mode are explained below.
Mode of Operation
Key Parameter Modify
Left Arrow
Previous Branch/Decrement #
Selects the previous branch in the
command tree, or
Decreases the Preset number when in
Preset Drive Parameter mode.
Move Left
Moves the flashing character selection
to the left, advancing the level of the
cursor setting.
For example: 00052 00 0005 200
Right Arrow
Next Branch/Increment #
Selects the next branch in the com-
mand tree, or
Increases the Preset number when in
Preset Drive Parameter mode.
Move Right
Moves the flashing character selection
to the right, lowering the level of the
cursor setting.
For example: 0005 200 00052 00
Down Arrow
Next Parameter
Selects the next parameter down the
branch of the command tree.
Decrement Character
Decreases the selected character(s).
For example: 2 1, or B A
Up Arrow
Previous Parameter
Selects the next parameter up the
branch of the command tree.
Increment Character
Increases the selected character(s).
For example: 1 2, or A B
Up & Down
Arrows
Press both keys at the
same time
Not functional in this mode. Undo Change/Escape
Restores a changed parameter to its
original setting.
NOTE: This command must be per-
formed before moving to another
parameter or branch.
Mode/Enter
Next Mode/Last Parameter
When displaying a parameter, enters
the Modify mode of operation.
When displaying a branch title, selects
the last parameter modified in branch.
Next Mode
Returns the display to the Parameter
mode of operation.