Dascom 7010 PrintServer Manual - Manual (Page 79)

Print Server Port Settings
Print Server User Manual 79
4. Select the desired settings from the COM1 list boxes; see:
Table 5
Ö
79.
5. Click OK to confirm.
ª
The setting is saved.
Table 5: COM1 Parameters
Parameters Description
Baud rate Specifies the baud rate for data transfer.
Parity Specifies the parity bit for the detection of incorrectly
transmitted bit sequences (parity check).
The following settings are possible:
- none = no parity check
- even = even parity check
- odd = odd parity check
Data bits Specifies how many data bits will be transferred in one data
packet.
Stop bits Stop bits mark the end of a data transfer unit and allow the
recipient of a data transfer to synchronize the data flow.
Flow control Defines the handshake procedure to control the data flow
between print server and printer. The following settings are
possible:
- none = handshake is disabled
- xon/xoff = software handshake is enabled
- dsr/dtr = hardware handshake is enabled
- both = software and hardware handshake are enabled