Dascom 7010 PrintServer Manual - Manual (Page 169)

Supported Network Protocols
Print Server User Manual 169
15.3 IPv6
You can integrate the print server into an IPv6 network and
configure several IPv6 settings.
Requirements
;
The print server is connected to a network that supports IPv6.
Proceed as follows:
1. Start the PRINTSERVER Homepage or start the
PRINTSERVER-NetTool and double-click the print server in the
print server list.
2. Select Configuration – IPv6.
3. Configure the IPv6 parameter; see: Table 16
Ö
169.
4. Click Save or OK to confirm.
ª
The settings are saved.
Table 16: IPv6 Parameters
DHCP
BOOTP
ARP/PING
ZeroConf Enables/disables the protocols 'DHCP', 'BOOTP',
'ARP/PING', and 'ZeroConf'.
Protocols offer various possibilities to save the IP
address in the print server. (See: ’Saving the IP
Address in the Print Server’
Ö
15).
We recommend disabling these options once an IP
address has been assigned to the print server.
Parameters Description
Parameter Description
IPv6 Enables/disables the IPv6 functionality of the print
server.
IPv6 address Defines a print server IPv6 unicast address assigned
manually in the format n:n:n:n:n:n:n:n.
Every 'n' represents the hexadecimal value of one of
the eight 16 bit elements of the address. An IPv6
address may be entered or displayed using a
shortened version when successive fields contain all
zeros (0). In this case, two colons (::) are used.