Dascom 7010 PrintServer Manual - Manual (Page 156)

Maintenance
Print Server User Manual 156
Resetting External
Print Servers
* Depending on the print server model, the print server is disconnected via the power switch
or by removing the power cable.
[Phase 1] Print Server Reset [Phase 2] Device start
Turn the printer off /
Disconnect the power socket Turn the printer off /
Disconnect the power socket
Press the status button and
keep it pressed. Turn the printer on /
Reconnect the power socket
Turn the printer on /
Reconnect the power socket
Wait until the Activity- and
Status-LED start blinking
simultaneously.
The Reset Mode is activate. Press the status button for a
short time.
Release the status button for
about 2 seconds.
The LEDs blink alternatingly.
Press the status button once
again and keep it pressed.
The LEDs blink simultaneously.
After few seconds only the
Activity-LED blinks consistently.
Release the status button.
[Phase 3] Status Check