Dascom 7010 PrintServer Manual - Manual (Page 123)

Internet Protocol Security (IPsec)
Print Server User Manual 123
Defining SA Templates
An SA template contains information about the authentication as
well as the key exchange between the print server and the remote
server. You can create a maximum of 4 SA templates.
Proceed as follows:
1. Start the PRINTSERVER Homepage.
2. Select Configuration – IPsec.
3. Select Edit rules.
4. Select Edit SA templates.
5. Specify the SA template; see: Table 10
Ö
123.
6. Click Save to confirm.
ª
The settings are saved.
Table 10: SA Template Parameters
Parameter Description
Name Name of the IPsec template.
You can enter a maximum of 16 characters.
Authentication type Specifies the procedure for the authentication of the remote
server. Two procedures are available:
- authentication via pre-shared key
- authentication via certificates.
(For the installation of certificates into print servers; see:
Ö
98.)
Verify certificate Specifies the type of certificate required for the certificate-based
authentication.
- Disabled: A self-signed certificate is sufficient for the
authentication. (Upon delivery, a self-signed certificate is stored
in the print server).
- Enabled: A root certificate is required for the authentication.
Pre-Shared Key Specifies the Pre-Shared Key (PSK).
You need the key if the ’Pre-Shared Key’ procedure has been
selected as ’Authentication type’.
You can enter a maximum of 16 characters.
IKE Specifies the template to be used for the automatic key
exchange.