Dascom 7010 PrintServer Manual - Manual (Page 55)

Print Server Installation
Print Server User Manual 55
Modifying an
Existing Printer Port
You can modify the settings of a printer port.
Proceed as follows:
1. Click 'Start' > 'Settings' > 'Printers and Faxes'.
2. Select the printer from the list.
3. Select File – Settings from the menu bar.
The Properties dialog appears.
4. Select the Ports tab.
5. Select the port from the list.
6. Click Configure. The dialog TCP/IP Port Configuration appears.
7. Configure the parameters; see: Table 3
Ö
55.
8. Click OK to confirm.
ª
The settings are saved.
Table 3: Changing the Port Configuration
Parameters Description
Time out If an error occurs during the sending of the print job, the print job
will automatically be sent again. You can limit the duration of this
process by defining a time out (1 - 120 min).
This will prevent the process from being repeated endlessly and
from blocking other connections.
SNMP monitoring Enables/disables the reception of printer status messages.
If parameter changes are controlled by a print server password,
you must enter the password for the SNMP monitoring into the
'Community' box. If no password is used, you must enter 'public'.
Authentication Enables/disables the option 'Authentication'; see: ’Encrypted
Socket Printing with Certificate Validation (Windows)’
Ö
85.
Use proxy server You can print via a proxy server. Tick 'Use proxy server' and
enter the IP address and the port number of the proxy server.