Dascom 7010 PrintServer Manual - Manual (Page 217)

Appendix - Parameter List
Print Server User Manual 217
Table 29: Parameter List - IPsec
Parameter Value Description
ipsec
[IPsec] on/off Enables/disables the use of IPsec.
(Pay attention to the IPsec test mode.)
ipsec_testmode
[Test mode] on/off Enables/disables the IPsec test mode.
We recommend using the test mode to
access the device in case of a
misconfiguration. In the test mode, IPsec
remains active until the hard reboot of the
device. IPsec is disabled after the hard
reboot.
ipsec_config 0 = Use configured
rules
1 = Use configuration files Specifies the way in which IPsec policies
are added to the print server.
ipsec_dhcp
[DHCP] on/off Enables/disables the filtering of DHCP
network activities by the IPsec policy.
- on = activity is always allowed
- off = activity is filtered via IPsec
ipsec_netbios
[NetBIOS] on/off Enables/disables the filtering of NetBIOS
network activities by the IPsec policy.
- on = activity is always allowed
- off = activity is filtered via IPsec
ipsec_slp
[SLP] on/off Enables/disables the filtering of SLP
network activities by the IPsec policy.
- on = activity is always allowed
- off = activity is filtered via IPsec
ipsec_slp
[FTP] on/off Enables/disables the filtering of FTP
network activities by the IPsec policy.
- on = activity is always allowed
- off = activity is filtered via IPsec
If all FTP network activities are allowed
(FTP = on), you must specify the ’Allow all’
action in the default rule.
ipsec_def_action
[action of the
default rule
]
0 = Allow all
1 = Drop all As specified in the IPsec default rule, this
is the action to be carried out if a data
packet matches the description of a filter.
ipsec_rule1_enabled
ipsec_rule2_enabled
ipsec_rule3_enabled
ipsec_rule4_enabled
[Rule 1-4] on/off Enables/disables the IPsec rules.