Dascom 7010 PrintServer Manual - Manual (Page 67)

Device Settings of the Print Server
Print Server User Manual 67
6.2 How to Configure the Device Time
You can set the time of the print server via a time server (SNTP
server) in the network. A time server is a computer networking
device that reads the actual time from a reference clock and
distributes this information to its clients. The time server is defined
via the IP address or the domain name.
Benefits and
Purpose
If the time server is activated, all print jobs that are handled by the
print server will get a time stamp. Date and time are then displayed
under Job History.
UTC The print server uses ’UTC’ (Universal Time Coordinated) as a basis.
UTC is a reference time and used as a time standard. The reference
point for UTC is the prime meridian.
Time zone The time received by the time server does not necessarily correspond
to your local time zone. Deviations from your location and the
resulting time difference (including country-specific particularities
such as Daylight Saving Time) can be handled by means of the ‘Time
zone’ parameter.
Requirements
;
A time server is integrated into the network.
What do you want
to do?
†
’Configuring the Device Time via the PRINTSERVER Homepage’
Ö
67
†
’Configuring the Device Time via the PRINTSERVER-NetTool’
Ö
68
Configuring the Device Time via the PRINTSERVER Homepage
Proceed as follows:
1. Start the PRINTSERVER Homepage.
2. Select Configuration – Time.
3. Tick SNTP.
4. Enter the IP address or the domain name of the time server into
the Time server box. (The domain name can only be used if DNS
was configured beforehand).