Dascom 7010 PrintServer Manual - Manual (Page 130)

Internet Protocol Security (IPsec)
Print Server User Manual 130
11.4 How to Enable IPsec Policies
After you have created IPsec policies via input mask or via
configuration files and implemented them on the print server, you
can enable a policy.
Test Mode We recommend using the test mode to access the device in case of a
misconfiguration. In the test mode, IPsec remains active until the
hard reboot of the device. IPsec is disabled after the hard reboot.
The ’test mode’ option is activated by default. After a successful
test, you must deactivate the test mode so that IPsec remains
permanently active.
Proceed as follows:
1. Start the PRINTSERVER Homepage.
2. Select Configuration – IPsec.
3. Specify the IPsec policy to be used.
- Use configured rules (use policy of the manually configured rules)
- Use configuration files (use policy of the loaded configuration
files)
4. Make sure that the test mode is on.
5. Tick IPsec.
6. Click Save to confirm. The setting is saved.
IPsec remains active until the device is hard rebooted.
7. Check the access to the device.
If you can no longer access the device, initiate a hard reboot of the
device and modify the IPsec policy.
8. Clear Test mode.
9. Click Save to confirm.
ª
IP traffic will be allowed based on the rules defined in the IPsec
policy.